RadioMaster TX16s Mods

RadioMaster TX16s Mark 2 V4 mod

Materials:

3d printed spacer (search Thingiverse)

Philips screws M2.3 x 12mm

Micro JST 1.25 connector 5 pins

Button self-locking switch 12mm

I did some modifications to my RadioMaster TX16s Mark 2 v4, 3d printed some spacers for the gimbal sticks to lower it down, added a button switch for secondary arming and added pads to the roller button.

RadioMaster TX16s Mark 2 V4 mod

Remove screws and side pads

RadioMaster TX16s mod

careful lifting the cover, remove the speaker wire connecting to the board, remember where its connected.

RadioMaster TX16s Mark 2 V4 mod

unfortunately at the time i was doing the mode, i ran out of micro JST 1.25 5 pins, fyi, if you plan to use the LED mode, this is also the socket you will connect the LED wires.

RadioMaster TX16s mod

next, insert the Button self-locking switch to the back cover

RadioMaster TX16s Mark 2 V4 mod

next, lift the cap pot and unscrew the module, this will give you access to the inner screw of the Gimbal stick

next, unscrew the screws holding the Gimbal sticks, carefully lift the Gimbal sticks and put the spacer.

put everything back and use the M2.3 x 12mm screws, do the same process to the other Gimbal stick.

next, for the roller button, disconnect Micro JST 1.25 connector, remove the screws, lift gently because the roller might fall-off, put double sided tape and foam.